Yamaha DVD-C940 - Manual (Page 18)

14
Notes:
– Multichannel output and downmixed stereo
output are not available simultaneously.
– When multichannel is selected as analog output.
The MIXED 2CH (Left/Right) will deliver the Center
channel data and not the downmixed Left/Right. In
some cases, the sound volume will be reduced.
Dolby Surround-compatible: Select this setting
when using an equipment with a Dolby Surround
Pro Logic decoder. In this setting, the 5.1 audio
channels (Dolby Digital, MPEG-2, DTS) are
downmixed to a Dolby Surround-compatible 2-
channel output.
3D-Sound: In a setup without rear speakers
(analog stereo output), 3D Sound remixes the six
channels of digital surround into a two-speaker
output while retaining all of the original audio
information. The result is the listening sensation of
being surrounded by multiple speakers.
During DVD or Video-CD playback, these values
can be selected directly with SOUND MODE.
– Night Mode
When set to ON, the dynamics of your sound
output are optimized. High volume outputs are
softened, enabling you to watch your favorite
action movie, etc. without disturbing others.
– CD Upsampling
Allows you to upsample your CD from 44.1 kHz
/ 16 bit to various higher sampling rate for
superior CD reproductions.
The selections are: 88.2kHz/24bits, 176.4kHz/
24bits and OFF.
The upsampling of CD can be toggle “ON/OFF”
via AUDIO on the remote control.
– PCM Output
Allows to select PCM digital output between
48kHz and 96kHz. When 48kHz has been
selected, 96kHz PCM data, (if available on disc)
will be converted to 48kHz.
Some 96kHz DVD are copy protected. If your
PCM output selection is 96kHz, the digital output
is downsampled to 48KHz.
– Karaoke vocal
Put this setting to ON only when a multi-channel
karaoke DVD is being played. The karaoke
channels on the disc will then be mixed into a
normal stereo sound.
1en 1en 1 2
Digital output
Analog output
Night mode
Karaoke vocal 3D sound
Dolby Surr-compat
Speakers Multi-channel
Stereo
Preparation