Yamaha CRW4260t-NB - Manual (Page 13)

Chapter 2 - Installing the Yamaha CRW4260t Drive
7
♦ Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON (with a jumper)
— Use this setting if the CRW4260t is the last device in the internal
SCSI daisy-chain.
Terminator OFF (without a jumper)
— Use this setting if devices other than the CRW4260t are in the inter-
nal SCSI daisy-chain and the CRW4260t is not the last device.
♦ Block size setting
Block size ON (with a jumper)
— Block Size is set to 512Byte/sector. This function is valid only for
workstations, such as those that run UNIX.
Block size OFF (without a jumper)
— Normally, use this setting.
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Terminator ON Terminator OFF
* Use jumper connectors to short the locations shown in black.
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Block size ON Block size OFF
* Use jumper connectors to short the locations shown in black.