ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 206)

HomeSafe User’s Guide
16-6 Maintenance
Figure 16-7 Upload Warning
The HomeSafe automatically restarts in this time causing a temporary network disconnect. In
some operating systems, you may see the following icon on your desktop.
Figure 16-8 Network Temporarily Disconnected
After two minutes, log in again and check your new firmware version in the System Status
screen.
If the upload was not successful, the following screen will appear. Click Return to go back to
the F/W Upload screen.
Figure 16-9 Upload Error Message
16.7 Configuration Screen
See the Firmware and Configuration File Maintenance chapter for transferring configuration
files using FTP/TFTP commands.
Click MAINTENANCE, and then the Configuration tab. Information related to factory defaults,
backup configuration, and restoring configuration appears as shown next.