ZyXEL Communications 10 - Manual (Page 301)

ZyWALL 10~100 Series Internet Security Gateway
System Maintenance & Information 23-1
Chapter 23
System Maintenance & Information
This chapter leads you through SMT menus 24.8 to 24.10. The Real Time Chip (RTC) applies to
the ZyWALL 100, 50 and 10W.
23.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main router firmware. The CI provides much of the same
functionality as the SMT, while adding some low-level setup and diagnostic functions. Enter the CI from
the SMT by selecting menu 24.8. Access can be by Telnet or by a serial connection to the console port,
although some commands are only available with a serial connection. See the included disk or zyxel.com
for more detailed information on CI commands. Enter 8 from Menu 24 - System Maintenance. Type
exit to return to the SMT main menu when finished.
Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.
Figure 23-1 Command Mode in Menu 24
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Firmware Update
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number: