Yamaha RX-V393RDS - Manual (Page 30)

30
1
Tune to a desired station.
(Refer to the previous page for tuning procedure.)
2
Select a desired group (A – E) of preset stations
confirming it on the display.
3
4
Select a preset station number where you want to
program the station before the “MEMORY” indicator
goes off from the display.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to preset station numbers
on other groups in the same way by selecting other groups
in step 2.
1 1
Select the group of preset stations.
2 2
Select the preset station number.
Notes
•
A new setting can be programmed in place of the former
one.
•
For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if this unit is turned into the standby
mode or the power plug is disconnected from the AC outlet or
the power is cut due to temporary power failure. If, however,
the power is cut for more than one week, the memory may be
erased. If so, it can be re-programmed by simply following
the PRESET TUNING steps.
MANUAL PRESET TUNING
This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station by only
selecting the preset station number where it is stored. Up to 40 stations (8 stations x 5 groups) can be stored.
PRESET TUNING
To store stations To recall a preset station
2, 1 1 3 4, 2 2
MAN’L/AUTO FM
MEMORY
MEMORY
A/B/C/D/E
PRESET
A/B/C/D/E
Flashes on and off
for about 5 seconds.
PRESET
MHz
AUTO
STEREO
0 20 l00
CONCERT HALL
Shows the displayed station has been
programmed to A1.
l6 20
28
40
60
l2
8
4
2
0 –dB
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8