Yamaha RX-V361 - Manual (Page 16)

12
En
Connections
Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty,
this unit cannot reproduce the input sources accurately.
■ Before connecting to the SPEAKERS
terminal
A speaker cord is actually a pair of insulated cables
running side by side. Cables are colored or shaped
differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (red)
terminals of this unit and your speaker. Connect the plain
cable to the “–” (black) terminals.
Remove approximately 10 mm (3/8”) of insulation
from the end of each speaker cable and then
twist the bare wires of the cable together to
prevent short circuits.
Connecting speakers
Caution
• Use speakers with the specified impedance shown on the rear panel of this unit.
• If you are to use 6 ohm speakers, be sure to set “SP IMP.” to “6
Ω MIN” before using this unit (see page 13).
• Before connecting the speakers, make sure that this unit is turned off.
• Do not let the bare speaker wires touch each other or let them touch any metal part of this unit. This could damage
this unit and/or speakers.
• Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the
speakers away from the monitor.
MULTI CH INPUT
COMPONENT VIDEO
DIGITAL INPUT
XM
VIDEO
ANTENNA SPEAKERS
L R L R
SURROUND CENTER FRONT B
AUDIO OUTPUT
L
1
2
3
R
L
R
L R
DVD DTV/CBL DVR CD
SUB
WOOFER
IN OUT CENTER
SUBWOOFER
SURROUND FRONT
DVD
OPTICAL
COAXIAL
CD
DTV/
CBL
DVD
P R
P B
Y
DTV/CBL DVR
DVD DVR
AM
FRONT A
GND
FM
75
IN OUT DTV/CBL
MONITOR
OUT
MONITOR
OUT
MD/
CD-R
OUT
(REC)
IN
(PLAY)
Subwoofer
Center
speaker
Front speakers (B)
Left Right
Surround speakers
Front speakers (A)
Left Right
Left Right
(U.S.A. model)
10 mm (3/8”)