Zanussi ZGL62IT - Manual (Page 10)

Problem Possible cause Remedy
The flame is blow out immediately af-
ter ignition
• Thermocouple is not heated suffi-
cient
• After lightning the flame, keep the
knob pushed for approximately 5
seconds.
The gas ring burns unevenly • Burner crown is blocked with food
residues
• Make sure that the injector is not
blocked and the burner crown is
clear of food particles.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, speak your dealer or the local Service Force
Centre.
If you operated the appliance incorrectly, or the in-
stallation was not carried out by a registered engi-
neer, the visit from the customer service technician or
dealer may not take place free of charge, even during the
warranty period.
Labels supplied with the accessories bag
Stick the adhesive labels as indicated below:
MOD.
PROD.NO.
SER.NO
DATA MOD.
PROD.NO.
SER.NO
DATA
MODEL MODEL
MOD.
PROD.NO.
SER.NO.
03 IT
MADE IN ITALY
TYPE
230V-50Hz
IP20 0049
1 2 3
1 Stick it on Guarantee Card and send this part
2 Stick it on Guarantee Card and keep this part
3 Stick it on instruction booklet
These data are necessary to help you quickly and correct-
ly. These data are available on the identification plate from
the injectors kit.
• Model description .................
• Product number (PNC) .................
• Serial Number (S.N.) .................
Use the original spare parts only. They are available at
Service Force Centre and approved spare parts shops.
Technical data
Hob dimensions
Width: 580 mm
Length: 500 mm
10