ZyXEL Communications GS-3012F/3012 User Manual

Page 159

Advertising
background image

Chapter 21 Multicast

GS-3012/GS-3012F User’s Guide

159

Figure 82 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN

The following table describes the labels in this screen.

Table 52 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN

LABEL

DESCRIPTION

Mode Select

auto to have the Switch learn multicast group membership information of

any VLANs automatically.
Select fixed to have the Switch only learn multicast group membership

information of the VLAN(s) that you specify below.
In either auto or fixed mode, the Switch can learn up to 16 VLANs (including up to

three VLANs you configured in the MVR screen). For example, if you have

configured one multicast VLAN in the MVR screen, you can only specify up to 15

VLANs in this screen.
The Switch drops any IGMP control messages which do not belong to these 16

VLANs.

Note: You must also enable IGMP snooping in the Multicast

Setting screen first.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch

loses these changes if it is turned off or loses power, so use the Save link on the

top navigation panel to save your changes to the non-volatile memory when you

are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

VLAN

Use this section of the screen to add VLANs upon which the Switch is to perform

IGMP snooping.

Name

Enter the descriptive name of the VLAN for identification purposes.

VID

Enter the ID of a static VLAN; the valid range is between 1 and 4094.

Note: You cannot configure the same VLAN ID as in the MVR

screen.

Add

Click Add to insert the entry in the summary table below and save your changes to

the Switch’s run-time memory. The Switch loses these changes if it is turned off or

loses power, so use the Save link on the top navigation panel to save your

changes to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to reset the fields to your previous configuration.

Clear

Click this to clear the fields.

Advertising