Zanussi DW 24 - Manual (Page 22)

Water outlet hose
connection
The end of the drain hose can be connected in the
following ways:
1- To the sink outlet siphon, securing it if necessary
with a clip.
2- Hooked over the edge of the sink using the special
curved plastic guide provided.
3- To a wall outlet provided with a vent-hole, minimum
internal diameter 4 cm.
The waste connection must be at a height of between 30
cm (minimum) and 100 cm (maximum) from the floor.
It makes no difference which way the drain hose faces,
either to the right or left of the dishwasher.
Ensure the hose is not bent or squashed as this could
prevent or slow down the discharge of water.
If you use a drain hose extension it must be no longer
than 2 metres and its internal diameter must be no
smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than
the diameter of the hose provided.
The sink plug must not be in place when
the machine is draining as this could cause
the water to siphon back into the machine.
22 PWA05UK
min 30 cm max 100 cm
min 4 cm
Ш 21
Ш 18
CS09
2 3 1
max 100 cm
min 30 cm max 100 cm
max 100 cm + 2 m max
CS10
Ш 18 Ш 21