Yamaha DSP-AX861SE - Manual (Page 34)

32
En
Optimizing the speaker setting for your listening room
■ If an error screen appears
Press Dk / n / l / h to select “RETRY” or
“EXIT” and then press D
ENTER.
The following display is an example where “E-9:USER
CANCEL” appears in the OSD.
Choices: RETRY, EXIT
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
■ If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
“AUTO:RESULT” display. Check the warning messages
to correct your speaker settings.
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press D
ENTER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
2
Press Dl / h repeatedly to toggle between
the warning displays.
y
• For details about each warning message, see the “AUTO
SETUP” section in “Troubleshooting” on page 96.
• When the corresponding warning message is not
applicable to a speaker, “– –” is displayed instead.
3
Press D
ENTER to return to the top
“AUTO:RESULT” display.
Note
AUTO:ERROR
. E-9:USER CANCEL
Don't operate
any function.
>RETRY EXIT
[ ]/[ ]:Select
[ENTER]:Enter
[ [
AUTO:RESULT
RESULT
. WARNING(3)
>SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
SP : 3/4/0.1
DIST: 4.50/5.30m
LVL : -9.0/+6.5dB
WARNING:W-1
<OUT OF PHASE>
Reverse Channel
FL
--
CENTER
PL
PR
SL SR
SBL SBR
[ ]/[ ]:Select
[ENTER]:Return
[ [