Zone 2 (u.s.a., canada and australia models only), Zone 2, Zone 2 connections – Yamaha RX-V800 User Manual
Page 58: U.s.a., canada and australia models only), Example of a system configuration and connections
54
REMOTE CONTROL OUT
REMOTE CONTROL IN
ZONE 2 AUDIO OUT
OUT
IN
OUT
IN
REMOTE
CONTROL OUT
ZONE 2
(U.S.A., Canada and Australia models only)
You can make up a multi-room audio system with this unit. You can enjoy an audio source selected with INPUT l / h
(or input selector buttons) in the second room (Zone 2).
Only analog signals are sent to the second room. For any source you want to listen to in the second room, you must
connect the analog output jack from the source to the corresponding analog input jack on this unit.
Zone 2 Connections
To use the multi-room functions of this unit, you need the following additional equipment:
• An infrared signal receiver in the second room
• An infrared emitter in the main room
This emitter transmits the infrared signals from the remote control in the second room to the main room
(for example, to a CD player).
• An amplifier and speakers for the second room
y
• Since there are so many ways to connect and use this unit in a
multi-room installation, we recommend that you consult with
the nearest authorized YAMAHA dealer or service center for
the zone 2 connections which will best meet your requirements.
• Some YAMAHA models are able to connect directly to the
REMOTE CONTROL OUT jack of this unit. If you own these
products, you may not need to use an infrared emitter.
This unit
■ Example of a system configuration and connections
Main room
CD player
(or other component)
This unit
Infrared emitter
Second room
Amplifier
Remote control
Infrared signal
receiver
Notes
• When not using the main room, turn down the volume of this unit in the main room. Adjust the Zone 2 volume with the control on
the amplifier in the second room.
• DO NOT USE the Zone 2 feature for CDs encoded with DTS.