Installation guide, Installation for sli/crossfire users – ZEROtherm ZERO THERM GX800 User Manual

Page 4

Advertising

◆

◆ Installation for SLi/CrossFire users

1. Attach the memory heat sinks

Remove the previous VGA cooler from your VGA
card.
Attach 8 pcs of memory heat sinks on the RAM
of your VGA card like <picture 6>.

※ The thermal tapes on the memory heat sink

ate not reusable because the adhesiveness will be
reduced after their first attachment.

2. Paste the thermal grease on your GPU (or VPU)

Paste the thermal grease on the core your GPU (or
VPU) of your VGA card like <picture 7>.

3. Install the

3. Install the ⑥

⑥

⑥ SLi/CrossFire

SLi/CrossFire

SLi/CrossFire knurling

knurling

knurling----nuts

nuts

Install the ⑥ Sli/CrossFire knurling-nuts on the
VGA cooler like <picture 8>.

※Please check the list of Compatible VGA Cards

& Screws Installation Holes before installing the
screws.

4. Fasten

4. Fasten ⑦

⑦

⑦ SLi/CrossFire

SLi/CrossFire

SLi/CrossFire Spring

Spring

Spring----screws

screws

Fit the VGA cooler and the installed ⑥
SLi/CrossFire knurling-nuts

into the holes on

your VGA card. Fasten ⑦ SLi/CrossFire spring-
screws

with a screw driver from the bottom of

your VGA card like <picture 9>.

※Make sure that the base of the VGA cooler and

the GPU (or VPU) are completely in contact with
each other.

※Excessive force may result in malfunction or

damage to the core of your GPU (or VPU).

5. Connect the fan

5. Connect the fan----connector

connector

Insert your VGA card into the PCI (or AGP) slot
and connect the 3-pin connector to your
motherboard or to your power supply unit like
<picture 10>.

※ Do not connect the 3-pin connector to your

VGA card

Installation Guide

Please read this installation guide carefully before installation

Advertising

Popular Brands

Popular manuals