For an ibm-pc computer with dos or windows, Scsi card and software, For a macintosh computer – Yamaha CDR200tx User Manual
Page 12: Chapter 1 - system configuration
Chapter 1 - System Configuration
4
Chapter 1 - System Configuration
In order to use the CDR200tx, you will require the following.
For an IBM-PC computer with DOS or Windows
The following operating environment is required:
•
An IBM/AT or compatible PC with a 486/33MHz or better CPU
•
A vacant slot in which to install a SCSI card or a pre-installed
SCSI card
•
Windows 3.1 or later, or Windows 95
•
Sufficient hard disk space
Note:
You will need about twice as much space on your hard disk as that
required by the data you wish to write to CD-ROM.
SCSI card and software
Yamaha CDR200tx is a “SCSI” device. You will need to install a
SCSI card and some mastering (writing) software in your host com-
puter to connect the CDR200tx.
We recommend the following:
Adaptec SCSI cards: AHA-2940 (PCI), AHA-284x (VL), AHA-2740
(EISA), AHA-154x (ISA), etc.
Use a mastering (writing) software application that supports the
CDR200tx.
For a Macintosh computer
The following operating environment is required:
•
A Macintosh computer that is equipped with a CPU of 68040 or
higher