Yamaha RX-V10 - Manual (Page 21)

19
English
10
Adjust the sound output levels of the center
speaker and the rear speakers by using the
LEVEL key so that they become almost as same
as that of the front speakers.
● When the test tone is output from the center speaker,
pressing the LEVEL key changes the output level of
the center speaker.
● When the test tone is output from the rear speakers,
pressing the LEVEL key changes the output level of
the rear speakers.
* Pressing the + side raises and the – side lowers the
level.
11
Cancel the test tone.
Stops flashing and disappears
Notes
● Once you have completed these adjustments, you can
adjust whole sound level on your audio system by
using the VOLUME control (or the VOLUME keys on
the remote control transmitter) only.
● If you use external power amplifiers, you may also use
their volume controls to achieve proper balance.
● In step 10, if the center channel mode is in the
“PHANTOM” position, the sound output level of the
center speaker cannot be adjusted. This is because in
this mode, the center sound is automatically output
from the left and right front speakers.
● If the selected input source mode is “DVD 5cH”, the
test tone generator will not function.
REC/PAUSE DIR B DIR A PLAY
PLAY
DVD/LD
2CH/5CH
PRESET A/B/C/D/E – +
LEVEL
DELAY/REAR
/CENTER TEST EFFECT
PROGRAM PROLOGIC ENHANCED
– +
TAPE A/B
ON/OFF
TUNER
VCR
11
10
TEST WIDE
TEST WIDE
TEST
TEST
LEVEL – +
Adjustable
Adjustable