Yamaha CX-1 - Manual (Page 4)

4
CONNECTIONS
● Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other
components to which connections are being made.
● When making connections between this unit and other components, be sure all connections are made correctly, that is to say L
(left) to L, R (right) to R. Also, refer to the owner’s manual for each component to be connected to this unit.
* : Refer to “ABOUT THE ACCESSORY COMPONENTS ON THE REAR PANEL” on page 6.
* The TAPE 3 terminals gain higher Signal-to-Noise Ratio than the TAPE 1 or TAPE 2 terminals. If you will
use a Digital Compact Cassette recorder or Minidisc recorder, etc., it is recommended to connect such a
component to the TAPE 3 terminals.
<
CX-1
>
AC OUTLETS REMOTE
CONTROL
PRE OUT
L
R
AUX TAPE 1 TAPE 2 TAPE 3 CD TUNER
L
R
L
R
L
R
PB REC OUT PB REC OUT PB REC OUT
L
R
CARTRIDGE LOAD MM/MC
220 Ω IK Ω
PHONO
POWER AMP
GND
SWITCHED
I20V 60Hz
200W MAX. TOTAL
I.7A MAX. TOTAL
LINE OUT AUDIO OUT OUTPUT LINE IN LINE OUT LINE IN
OUTPUT
LINE OUT
LINE IN
GND
OUTPUT
REMOTE CONTROL
INPUT
Turntable Compact disc player Tape deck 2
Power amplifier
(U.S.A. model)
To AC outlet
Tape deck 3 Tape deck 1 Video cassette player,
LD player, etc. Tuner