ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 - Manual (Page 120)

Chapter 13 Log Screens
ZyXEL NWA-1100 User’s Guide
120
Use sys logs category followed by a log category and a parameter to decide what to record
Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order
to record logs).
13.7.2 Displaying Logs
Use the sys logs display command to show all of the logs in the ZyXEL Device’s log.
Use the sys logs category display command to show the log settings for all of the log categories.
Use the sys logs display [log category] command to show the logs in an individual ZyXEL
Device log category.
Use the sys logs clear command to erase all of the ZyXEL Device’s logs.
13.7.3 Command List
The following table provides the commands that can be used for your ZyXEL Device to
configure the log settings.
Table 40 Log Command List
Table 39 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
error 0, 1, 2, 3
mten 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only
alerts for that category, and 3 to record both logs and alerts for that category.
KEYWORD DESCRIPTION
client Enable SYSLOG client
ipaddr SYSLOG server IP address
port SYSLOG server port
Email server E-mail server address
Email subject E-mail subject
Email Address E-mail address
Email SmtpAuthEnable SMPTP auth enable when e-mail log
Email User E-mail user name
Email Password E-mail password
Email Schedule E-mail schedule mode
Email Day E-mail schedule day
Email Hour E-mail schedule hour
Email Minute E-mail schedule minute
Email Clear Clear log after e-mail
Email Now Send e-mail now