Yamaha CD Recordable/Rewritable Drive CRW-F1-NB - Manual (Page 26)

Preparing the CRW-F1 Drive
17
The following describes how to install the CRW-F1 drive as an additional drive for
example.
1
Prepare to install.
Installing the CRW-F1 drive as an additional drive
Remove the front cover from the 5 ¼-inch drive bay.
Replacing
Remove all cables connected to the CD-ROM or other devices to be replaced.
Then remove the device itself from the computer.
• Be careful not to damage the various cables connected to the rear panel of the
CD-ROM drive.
• The audio cable is usually caught by the hook at the top of the connector.
Release the hook and remove the connector without using excessive force.
• Do not apply excessive force to the CD-ROM drive or cables.
• Hold the cable by the connector to remove the cable. Pulling the cable itself with
excessive force may damage the wires inside.
3 Install the CRW-F1 Drive
Note
Audio cable
IDE cable 4-pin internal power
cable