Zephyr Cypress AK7842ASX - Manual (Page 14)

12
www.zephyronline.com
Installation –
Remote Blower Preparation
1. Place 10” round adapter on top of hood and
secure with (4) M4x8 screws. Connect 10”
round duct work to 10” round adapter.
2. Install threaded end of external blower wiring
through external blower wiring knock out
located inside the hood.
3. Place cap over threaded end of external blower
wiring and secure by turning clockwise.
4. Connect 6 pin male connector from external
blower wiring to 6 pin female connector on
control board wire inside hood. Secure green
ground wire from external blower wiring to
ground screw on hood.
NOTE: For instructions on mounting the external and in-line blowers, please refer to the manual included
in the blower packaging or on our website: www.zephyronline.com
REMOTE BLOWER: WIRING DIAGRAM
White (common)
Black (high)
Blue (med)
Red (low)
Green (ground)
Remote Blower
Wiring Box
(hood)
Junction Box
(Remote Blower)
CBE-1000 EXTERNAL OR PBN-1000A IN-LINE BLOWER INSTALLATION