Yamaha DVX-S100 - Manual (Page 7)

3
INTR
ODUCTION
English
CHECKING THE ACCESSORIES
Check your package to make sure it contains the following items.
DVR-S100
Remote control
TV
CH
INPUT TUNER
MUTE CD–R
VCR
VIDEO 2
VIDEO 1
MD
AV SLEEP
POWER
TV MODE
POWER
VOL
REC
AUDIO SUBTITLE
SHIFT
CODE SET
1
HALL
2
JAZZ
SETUP
3
ROCK
ANGLE
4
ENTERTAINMENT
MARKER
5
SPORTS
6
MONO MOVIE
PLAY MODE
7
MOVIE 1
REPEAT
8
MOVIE 2
A–B
DVD
CD
AMP
9
/DTS
TOP MENU
LEVEL MENU SET MENU
TEST
ON SCREEN B. BOOST RETURN
0
SELECT
> –10
MATRIX 6.1
GROUP
CANCEL
STEREO
PAGE
MUTE
VOL
ABCDE
ENTER
PRESET
CH
PRESET
CH
Batteries (x2)
(AA, R06, UM-3)
AM loop antenna
Indoor FM antenna
(U.S.A., Canada and
General models)
(Europe, U.K. and
Australia models)
NX-SW100 (NX-S100S x4, NX-S100C, SW-S100)
Fasteners (4 sets)
for the center
speaker
Pads
(2 sets: 16 pieces)
Speaker cables
(for the rear speakers: 15m (x2),
for the front/center speaker:
5m (x3))
System connector
cable (5m x 1)
INSTALLING BATTERIES IN THE REMOTE CONTROL
Insert the batteries in the correct direction by aligning the
+ and – marks on the batteries with the polarity markings
(+ and –) inside the battery compartment.
1 Press the part and slide off the battery
compartment cover.
2 Insert the two batteries (AA, R06, UM-3 type)
with + and – oriented properly.
3 Slide the cover back on so that it snaps into
place.
1
3
2
■ Notes on batteries
• Change all of the batteries if you notice a decrease in
the operating range of the remote control.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline
and manganese batteries) together. Read the packaging
carefully as these different types of batteries may have
the same shape and color.
• If the batteries have leaked, dispose of them
immediately. Avoid touching the leaked material or
letting it come into contact with clothing, etc. Clean the
battery compartment thoroughly before installing new
batteries.
Preserving the manufacturer code
Replace batteries early before they become unusable.
The manufacturer code set by the user will be
preserved for about two minutes when batteries run
out or when they are removed. Note that the
manufacturer code setting may be lost if more than
two minutes elapses. Also, if you press any button on
the remote control accidentally while replacing
batteries, the manufacturer code will be lost.
Non-skid pads
(2 sets: 16 pieces)
Video pin cable
103_S100_01-09_EN 02.5.13, 1:26 PM 3