Zanussi ZKC5020 - Manual (Page 24)

• Impregnated plastic or nylon pads that are
not described as suitable for non-stick sau-
cepans.
• Abrasive cleaning pads, scourers and steel
wool pads.
• Chemical oven cleaners, e.g. aerosols and
oven pads.
• Rust stain, bath and sink stain removers.
• Any of the above products may cause dam-
age to the hob.
• It is dangerous to mix different cleaning
products. The chemicals in them may react
with each other with hazardous results.
• Sugar solutions must be removed from the
hob before the syrup has set otherwise dam-
age to the hob surface will occur.
• Avoid placing plastic items, foil or dishes on
the hot surface as this will cause damage to
the hob.
Cleaning the grill/oven
furniture
• All removable parts, except the grill pan han-
dle can be washed in the dishwasher.
• The grill pan, grill pan grid and oven shelves
may be cleaned using a soap impregnated
steel wool pad. Soaking first in hot soapy
water will make cleaning easier.
Cleaning inside the grill and
oven compartments
• The vitreous enamel main oven and grill
compartment can be cleaned using normal
oven cleaners with care. Ensure that the
manufacturers instructions are followed and
that all parts are well rinsed afterwards.
IMPORTANT!
Aerosol cleaners must not come into contact
with elements, the door seal, or any painted
finishes as this may cause damage.
Cleaning the door(s)
WARNING!
To prevent damaging or weakening the door
glass panels avoid the use of the following:
• Household detergents and bleaches.
• Soap impregnated pads unsuitable for non-
stick saucepans.
• Abrasive cleaning pads, scorers and steel
wool pads.
• Chemical oven pads or aerosols.
• Rust removers.
• Bath/Sink stain removers.
Cleaning between the outer and
inner door glass
WARNING!
Rough handling, especially around the edges
of the front panel, can cause the glass to break.
To clean the glass door panels
Clean the glass door panels using hot soapy
water, hob cleaner may also be used. Do not
use hob cleaner on the stainless steel or pain-
ted surfaces. Ensure that all parts are well
rinsed and thoroughly dried before attempting
to replace the glass.
24