ZyXEL Communications VL470M - Manual (Page 45)

VIZIO VL420M/VL470M User Manual
Version 3/25/2009 45
www.VIZIO.com
TV Menu
When you first turned on your HDTV you set up your TV for DTV / TV channels using the Initial Setup
screens. If you did not do this or if your setup has changed, you can do this from the TV
menu.
1. Press the MENU button on the remote control and the Picture menu will be shown on the screen.
2. Press
! or " on the remote control to highlight the TV menu, and then press #II to select it.
3. Press ! or " on the remote control to select a TV menu option.
4. Once the menu option is highlighted, press $ or # on the remote control to adjust the setting.
5. Press the MENU key once to return to the previous screen or repeatedly to return to your program if
the task has been completed.
Tuner Mode
Select Cable or Antenna depending upon which
equipment you have attached to the DTV / TV Input.
Auto Search
Automatically search for TV channels that are available
in your area. The TV will search for analog and digital
channels.
Partial Channel Search
If you believe channels are missed from the auto
search, you can do a partial channel search to look for
channel in a certain channel range again. Select to
scan for Analog, Digital, or both Analog/Digital
channels, then press the
" button to highlight the
“From” and “To” selection. Press the # button to select
the range of channel numbers you want to start
searching in. Press #II to start channel search.
Skip Channel
After the TV has stored all of the available digital channels in memory you will find that some channels
are too weak to watch comfortably or they may be channels you do not want to see. Press the # button
to select the channel to be skipped when using the CH
! or CH " buttons. You will still be able to select
this channel using the number buttons on the remote control.
MTS
This feature allows you to select the different languages the broadcaster is transmitting the audio with the
program you are watching. This signal is usually Spanish.
Time Zone
Setting the correct Time Zone for your area will ensure that the correct program times are shown after
pressing the INFO button on the remote control.
Daylight Saving
Setting the daylight saving time for your area will ensure that the correct program times are shown after
pressing the INFO button on the remote control.
Channel Info
Channel Info displays the technical information of the channel including channel number, frequency,
modulation type, status, SNR (signal noise ratio), and signal strength.