Operating sequence – Zanussi ZWG 6105 User Manual

Page 11

Advertising
background image

40

Operating sequence

1. Load the laundry
Open the door by
carefully pulling the door
handle outwards. Place
the laundry in the drum,
one item at a time,
shaking them out as

much as possible. Close the door.

2. Measure out the detergent and the fabric
softener

Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked

.

If required, pour fabric softener into the
compartment marked

(the amount used

must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
3. Select the required programme

The selector dial is divided into following
sections:

Cottons,

Synthetics

The green Start/Pause light starts to flash.
The selector dial can be turned either
clockwise or anticlockwise.

Position «Off» to Reset programme/Switching
OFF of the machine.
At the end of the programme the selector
dial must be turned to position
«Off», to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the red Start/Pause pilot light will
flash 3 times to indicate a wrong selection.
The machine will not perform the new selected
programme.

4. Select the spin speed or Night Cycle or
Rinse Hold option

Press the Spin
button repeatedly
to change the
spin speed, if you
want your laundry
to be spun at a
speed different
from the one
proposed by the
appliance.

The relevant light will light up.
Maximum speeds are:

Cottons: 1000, 1200 rpm depending on the
Model;

Synthetics, Handwash: 900 rpm

Delicates: 700 rpm;

No Spin

: By selecting this option, all

spinning phases are suppressed. On Cotton,
Synthetics and Delicates programmes, the
rinses will be performed with more water.
Rinse Hold

: by selecting this option the

water of the last rinse is not emptied out to
prevent the fabrics from creasing. When the
programme has finished the pilot lights «Door»
and «End» are alight, the Start/Pause and
«Wash» lights are off and the door is locked to
indicate that the water must be emptied out.

126.2936.33…ZWF615.qxd 15/5/08 11:44 Página 40

Advertising
This manual is related to the following products: