Zanussi ZPB 1260 - Manual (Page 5)

5
Control Panel
Push Buttons
1. - ON / OFF
2. - Cooking Functions Control
3. - Fast Heat Up Function
4. - Pyrolitic Function
5. - Decreasing Control (Time or Temperature)
6. - Increasing Control (Time or Temperature)
7.
- Time Function
"On/Off" Push Button
The oven must be switched on before setting any cooking
function or programme. When button
is pressed, the
oven symbol will come on the display and the oven light
will switch on (Fig. 1).
To switch off the oven, you can press button
at any
time. Any cooking function or programme will stop, the
oven light will switch off and the time display will show
the time of day only.
All the oven functions are controlled by an electronic
programmer.
You can select any combination of cooking function,
cooking temperature and automatic timing.
In the event of a power failure, the programmer will
keep all the settings (time of day, programme
setting or programme in operation) for about 3
minutes. If power is not restored within 3 minutes,
all the settings will be cancelled. When the power
is restored, the numbers in the display will flash,
and the clock/timer has to be reset.
Special functions
The following functions can be activated by pressing two
buttons at the same time:
- Child lock: press button
and button “ “.
- Beep on touch: press button and button “ “.
- Demo mode: press button B and button “ “.
For further details, see chapter “Safety and Energy Sav-
ing functions”.
Cooking Functions
display
Time
display
Temperature
display
1 2 3 4 5 6 7
Fig. 1
Cooling fan
The cooling fan operates during cooking. Air is expelled
through vents between the oven door and the control panel,
as shown in the diagram.
The cooling fan may run on after the oven is switched off
to keep the controls cool. This is quite normal.
The Safety Thermostat
This oven is provided with a safety thermostat. In case of
malfunctioning of the main thermostat, and consequent
over-heating, the safety device will stop the power supply
to the appliance. If this happens, call your local Service
Force Centre. Under no circumstances should you
attempt to repair the appliance yourself.