ZyXEL Communications P-2802H(W)(L)-I Series - Manual (Page 55)

Chapter 3 Internet and Wireless Setup Wizard
P-2802H(W)(L)-I Series User’s Guide
55
Figure 13 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
4 The next wizard screen varies depending on what mode and encapsulation type you use.
All screens shown are with routing mode. Configure the fields and click Next to
continue. See
Section 3.3 on page 58 for wireless connection wizard setup
"
When you use the connection wizard to configure the Internet access using
PPPoE, the ZyXEL Device is set to get an IP address from the ISP
automatically. To set up a static WAN IP address with PPPoE, use the
Network > WAN screen.
Table 6 Internet Access Wizard Setup: ISP Parameters
LABEL DESCRIPTION
Mode Select Routing (default) from the drop-down list box if your ISP give you one IP
address only and you want multiple computers to share an Internet account. Select
Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If
you select Bridge, you cannot use Firewall, QoS, DHCP server and NAT on the
ZyXEL Device.
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. This field is available only when you select Routing in the Mode field.
Choices are Ethernet and PPPoE.
Back Click Back to go back to the previous screen.
Next Click Next to continue to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above.
Exit Click Exit to close the wizard screen without saving your changes.