Lumex Syatems FREEDOM 80500 - Manual (Page 2)

Step 4
Parallel Arms:
1. Facing the walker, insert the right side arm into the front section (T) fitting and back
section (FOUR WAY) fitting. Insert the left side arm into the front section with the red
strap into the (T) fitting, back section insert into the (FOUR WAY) fitting.
2. Secure both arms with 1 each of the 1" stainless steel screws.
Step 5
PVC Back Section:
Add the PVC back to the rear section of the arms. Secure the PVC back into the female
fitting with 1 each of the 1" stainless steel screws.
Step 6
Swing Gate and Red Safety Strap:
Includes one parallel pole (longest) and two vertical poles. The parallel pole serves as
the main swing gate. The other two serve as a pivot points for the swing gate.
1. Slide the parallel pole into the taller pivot pole. Facing the walker, insert the pivot
pole into the (T) fitting on the right side. Secure the vertical pole with 1 each of the 1"
stainless steel screw.
2. Facing the walker, insert the shorter pivot pole into the (T) fitting into the left side.
Secure with 1 each of the 1" stainless steel screw.
The red safety strap serves as additional security for the swing gate. The red safety strap
must be secured to the gate when the walker is in use.
Step 7
Safety Bolt:
The pre-assembled walker has the strap attached to the (seat) base of the walker. Unroll
the strap to finish assembly and loop the strap on the swing gate. Secure the swing gate
with the red safety strap by snapping it to the swing gate prior to use of the walker. Red
safety strap must be on the right side of the walker.
NOTE:
MAKE SURE ALL SCREWS AND ADJUSTABLE PARTS ARE SECURED
PROPERLY PRIOR TO USING THE WALKER.
Graham-Field Health Products
2935 Northeast Parkway, Atlanta, Georgia 30360
telephone: 800-347-5678, 770-447-1609
fax: 800-726-0601, 678-291-3232
http://www.grahamfield.com