Z-Com ZMAX-8210-I - Manual (Page 29)

Figure 23 Retrieve and Backup Settings
‚
From the“Backup / Restore Settings” ，by clicking“Backup”，a pop-menu will appear,
suggesting you enter:C:\mercury.cfg. After “Confirm”, the mercury.cfg will be saved to your
hard disc.
‚
From the“Backup / Restore Settings” ，by clicking“Backup”，a pop-menu will appear,
suggesting you enter:C:\mercury.cfg. After “Retrieve”, the zmax8210 will retrieve your backup
file.
Backup and Retrieve Files via FTP：
‚
Enter the command ftp 192.168.1.1 admin and password,
‚ After successful commanding, enter“get mercury.cfg”. If the upgrade is successful, enter “get
mercury.cfg” and you’ll see the information as below. A file will be saved to your PC folder
following C:\mercury.cfg；
‚
Enter“put mercury.cfg” ，the file will be loaded to your ZMAX-8210.
Note：
C:\>ftp 192.168.1.1
Connected to 192.168.1.1
220 (vsFTPd 1.1.3)
User (192.168.1.1:(none)): admin
331 Please specify the password.
Password:
230 Using binary mode to transfer files. Login successful. Have fun.
ftp> get mercury.cfg
200 PORT command successful. Consider using PASV.
150 Opening BINARY mode data connection for /mnt/ramd/ mercury.cfg (11411 bytes).
226 File send OK.
ftp: 收到 11411 字节，用时 0.00Seconds 11411000.00Kbytes/sec.
ftp> put zmax8200.cfg
200 PORT command successful. Consider using PASV.
150 Ok to send data.
226 File receive OK.
ftp: 发送 11411 字节，用时 0.02Seconds 713.19Kbytes/sec.ftp> quit
221 Goodbye.
Chapter 5 Management - 23 -