ZyXEL Communications ZyXEL ZyAIR A-6000 - Manual (Page 5)

A-6000 High Speed, Long Range Ethernet Wireless Bridge
Information for Canadian Users v
Information for Canadian Users
The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operation, and safety requirements. The Industry Canada does not
guarantee that the equipment will operate to a user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. In
some cases, the company's inside wiring associated with a single line individual service may be extended by means
of a certified connector assembly. The customer should be aware that the compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the
supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
For their own protection, users should ensure that the electrical ground connections of the power utility, telephone
lines, and internal metallic water pipe system, if present, are connected together. This precaution may be particularly
important in rural areas.
Caution
CAUTION:
Notes and Warnings to the User and Installer
Caution:
¾
This Installation Guide is intended for use by the professional wireless LAN system installer.
¾ The device cannot be sold retail, to the general public or by mail order. It must be sold to dealers or have strict
marketing control.
WARNING: It is the responsibility of the professional installer to ensure that the system is used exclusively for fixed,
point-to-point operations.
Warning: When using the A-6000 in the United States (or where FCC rules apply), it is the responsibility of the
professional installer to ensure to control the output power not greater then the application (A-6000: 126.77mW)
Who Should Use this Guide
Installation of this device should be accomplished only by a qualified wireless LAN system installer who is:
¾
Knowledgeable of the use, installation and configuration procedures and associated networking components.
¾ Knowledgeable of each system component’s equipment User and Installation Guide.
¾ Knowledgeable of the installation and configuration procedures for the site’s network infrastructure system and
wiring.
¾ Knowledgeable of the installation procedures, safety, and code requirements for the site’s antenna, antenna
mast, antenna cabling, and installation. Teletronics highly recommends that the antenna installation be
performed by a qualified antenna installation professional.
Users should not attempt to make such connections themselves, but should contact the appropriate electrical
inspection authority, or electrician, as appropriate.
Note
This digital apparatus does not exceed the class A limits for radio noise emissions from digital apparatus set out in the
radio interference regulations of Industry Canada.