Xantech HD16D - Manual (Page 4)

08905120A - 4 -
SPECIFICATIONS
Video
Gain: 2 Volt non-terminated, 1 Volt terminated, 75 Ohms ±1%
Input Impedance: 75 Ohms
Output Impedance: 75 Ohms
Video Insertion Loss: 50 Hz to 10 MHz < .40 dB
Video Crosstalk: ≥ 70 dB @ 10 MHz
Return Loss: 50 Hz to 10 MHz 20 dB
Video Bandwidth: > 100 MHz
Video S/N Ratio: ≥ 70 dB @ 10 MHz
Video 2nd Harmonic @ 10MHz: -45 dB
Audio - Analog
Gain: Unity
Input Impedance: 20 kOhm
Output Impedance: 150 Ohm
THD: 0.05% at 1.0 Volts input level
Frequency Response: 0 to 60 kHz
Channel Separation: > 75 dB at 1 kHz
In to Out Isolation: 60 dB
Out to Out Isolation: 60 dB
Signal to Noise: >110 dB reference 2 Volts RMS output
Max Signal Level: 2.9 Volts RMS
Audio – Digital
Supports standard SPDIF digital audio. Unity gain when terminated into 75 Ohms (2 times gain high
impedance). Greater than 50 MHz of bandwidth to ensure minimal degradation. Can also be used as
a composite video distribution.
Xantech Corporation
13100 Telfair Avenue, 2/F
Sylmar, CA 91342
Installation Instructions, HD16D
© 2007 Xantech Corporation, Document #08905120A
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior
written consent from Xantech Corporation.
Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this
document.