Yamaha NS-P320 - Manual (Page 9)

E-
5
Mount the rear speakers on a shelf, rack or directly on the
floor, or hang them on the wall.
To mount the rear speakers on a wall by
using the holes on the speakers’ back
panels
Note
It is recommended that you connect the speaker cables to
the speaker’s terminals before attaching the bracket to the
speaker.
1
Put the provided pads at the four corners on the rear of
the rear speakers to prevent the rear speakers from
moving by vibrations.
2
Fasten screws into a firm wall or wall support as shown
in the figure.
3
Hang the holes on the protruding screws.
* Make sure that the screws are securely caught by the
narrow parts of the holes.
* You can use the lower holes on the rear of the rear
speakers.
WARNING
● Each speaker weighs 1.1 kg (2 lbs. 6 oz.). Do not
mount them on thin plywood or a wall with soft
surface material. If mounted, the screws may come
out of the flimsy surface and the speakers may fall.
This damages the speakers or causes personal
injury.
● Do not install the speakers to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause them to fall.
● To avoid accidents resulting from tripping over loose
speaker cables, fix them to the wall.
● Select a proper position on the wall to mount the
speaker so that no one will injure his/her head or
face.
Ⅵ Mounting the rear speakers
1
3
W
all/ w
all
suppor
t
Tapping screw
(Available at the
hardware store)
Min.
20 mm
60 mm
Diam. 3.5 to 4 mm
6 mm
Holes
2