ZyXEL Communications ADSL2+ Ethernet Gateway P-660R-T Series - Manual (Page 130)

P-660R-T Series User’s Guide
Chapter 15 Menu 2 WAN Backup Setup 130
Figure 63
Menu 2.1 - Traffic Redirect Setup
Active= No
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 15
Press ENTER to Confirm or ESC to Cancel:
Menu 2.1Traffic Redirect Setup
The following table describes the fields in this menu.
Table 39 Menu 2.1Traffic Redirect Setup
FIELD DESCRIPTION
Active. Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic redirect
setup. The default is No
Configuration
Backup Gateway
IP Address
Enter the IP address of your backup gateway in dotted decimal notation.
The Prestige automatically forwards traffic to this IP address if the Prestige’s
Internet connection terminates.
Metric This field sets this route's priority among the routes the Prestige uses.
The metric represents the "cost of transmission". A router determines the best route
for transmission by choosing a path with the lowest "cost". RIP routing uses hop
count as the measurement of cost, with a minimum of "1" for directly connected
networks. The number must be between "1" and "15"; a number greater than "15"
means the link is down. The smaller the number, the lower the "cost"
When you have completed this menu, press [ENTER] at the prompt “ Press ENTER to Confirm
or ESC to Cancel: ” to save your configuration, or press [ESC] at any time to cancel.