Yamaha DTX RS700 - Manual (Page 6)

4
RS500/RS700 Owner’s Manual
1. Remove the rack from its box and stand it up with the drum trigger module clamp positioned on the right as shown in
Figure 1.
2. With the rack standing up, loosen the bolts q located on the right and rotate the right leg clockwise from the left until it
comes fully around as shown in Figure 1 Top view.
• The bolts q can be found on the rear of the clamp on the right pillar, which is located behind the left leg.
3. Loosen the bolts w located on the left in Figure 2 and rotate the left leg towards you until it is positioned as shown in
Figure 2 Top view.
4. Tighten the bolts loosened in Steps 2 and 3 above.
Setting up RS700
[Figure 1]
Bolts q
Left leg
Right leg
Drum trigger
module clamp
Left leg
Right pillar Right pillar Left pillar
2
Left leg
Right leg
Left pillar
Right pillar
2
[Figure 1 Top view]
[Figure 2 ]
Bolts w
Right leg
Left leg
Right pillar
Left pillar
Drum trigger
module clamp
3
[Figure 2 Top view]
Left leg
Right leg
Left pillar Right pillar
3
CAUTION
• The rack may topple over and cause
injury if the left and right legs are
opened any wider than shown in the
figure below. You should not, there-
fore, exceed the dimensions indicated.
rs500_700_en_1224.fm Page 4 Friday, December 24, 2010 9:15 AM