SINBO SVC 3467 - Manual (Page 12)

2. To rewind the power cable, press the button
with one hand and guide the cable with the other hand to ensure
that it does not whip causing damage.
Emptying dust container
Empty the dust container at the latest when the sucked in quantity of
dirt in the dust container has reached the “MAX” mark or the suction
power has dropped.
1. Switch off the vacuum cleaner and disconnect the plug from the mains.
To do this always pull on the plug and not on the cable.
2. Release the dust container by pressing down the release button.
3. Lift the dust container forwards out of the cylinder vacuumcleaner.
4. When emptying the dust container, hold it low over a dustbin.
5. Press the open button. The base opens and the dust runs into the
dustbin.
6. Carefully knock the remaining dust loose.
7. Close the base.
8. Place the dust container onto the cylinder vacuum cleaner.
9. Check whether the dust container is securely seated.
Cleaning the motor filter
1. Turn off and unplug cleaner.
2. remove the dust container.
3. Open the dust container cover and take he filter out.
4. Hold the protective motor filter over a dustbin. For a rough clean,
gently knock over a dustbin.
5. Insert the dry protective motor filter back into its holder.
6. Place protective motor filter together back into its receptacle.
7. Replace the filter cover by hooking it precisely from above first. The
engage the lock by pressing it until audibly clicks into place.
8. Place the dust container onto the cylinder vacuum cleaner.
9. Check whether the dust container is securely seated.
IMPORTANT! Never use the vacuum cleaner without a motor filter.
Cleaning the exhaust air filter
The exhaust air filter cleans the air a final time before it leaves the vacuum cleaner. You
can clean the exhaust air filter as follows:
- 11 -