Zanussi DE 6965 - Manual (Page 17)

17
Select the desired delay time by pressing the
same push button until in the digital display
appears the required time (up to a maximum
of 12 hours).
To cancel the time setting press the DELAY
push button until h 0 appears in the digital
display.
If the setting has been made with the door
open, close the door and the countdown will
start automatically after 5 seconds.
In the digital display the delay time will
decrease from hour to hour and the flashing h
confirms the delay start is counting down.
If the setting has been made with the door
closed, the countdown will start automatically
5 seconds after the last pressure of a push
button.
Once the delayed time has elapsed, the
programme will start automatically, in the
digital display will appear the time duration of
the programme and the indicator light of the
phase under way will illuminate.
The duration of the programme visible in the
digital display will start to decrease from
minute to minute.
8. At the end of the washing
programme
The dishwasher will automatically stop and an
intermittent audible signal informs you that the
programme has ended.
In the digital display will appear three zeros
(000), the indicator lights of the ended
programme and of the phases turn off.
The ON-OFF indicator light will remain on
until the dishwasher is switched off.
Switch off the dishwasher by pressing the ON-
OFF push button.
Wait 15/20 minutes before opening the
dishwasher’s door; in this way you will
avoid burning yourself when removing the
dishes and avoid also the damage of the
nearby furniture caused by the escape of
steam.
Empty the lower basket first and then the
upper one; this will avoid water dripping from
the upper basket onto the dishes in the lower
one.
The programme has ended only when the
end of programme audible signal is heard
and the indicator lights of the
programme and the phases (including
DRYING) are off.
In the digital display three zeros must
appear.
If you do not wait for the end of the
programme it will not be possible to start a
new programme if first you do not cancel
the previous.
(For instructions on how to cancel a
programme see point 9)
9. To cancel a programme in
progress
This is possible both with the door opened or
closed.
With a programme in progress, press the
push button of the programme in progress (for
about 5 seconds).
After these 5 seconds the dishwasher returns
to setting mode and you can select a new
washing programme.
Do the same operation if you want to cancel
the countdown of the delay start.
In setting mode with open door, simply
press the ON-OFF push button.
Before the decrease of the 5 seconds after
the last pressure of a push button, simply
press the ON-OFF push button.
Important!
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Care must be taken if the door is opened
during the hot phase or immediately after
a programme has finished, as steam may
escape.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.