Zenoah TR2001 - Manual (Page 15)

GB-15
G
B
3. Take out the spool and pull off the old line. Put one
end of new line through the spool holes and pull it
until the length is equal between each part of the line.
4. Wind up the line in the correct direction as indicated
on the spool.
5. Hook each end of the line in the slot on the edge of
the spool, and then put the ends through the eyelets
on the housing. Make sure that the spring and the
washers are in place.
6. While holding the spool against the housing, pull the
line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook on
the housing, press the cap against the housing until it
clicks.
PROCEDURES TO BE PERFORMED AFTER
EVERY 100 HOURS OF USE
1. Remove the muffler, insert a screwdriver into the vent,
and wipe away any carbon buildup. Wipe away any
carbon buildup on the muffler exhaust vent and cylin-
der exhaust port at the same time.
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way
in between the clutch lining and drum, and if it has,
wipe it away using oil-free, lead-free gasoline.
REFILLING TRIMMING LINE
1. F o r r e p l a c e m e n t l i n e , u s e a d i a m e t e r o f
2.4 mm. The spool is capable for a line upto
6 m on the 4" head. Avoid using a larger line as it may
cut down the trimming performance.
WARNING
For safety reasons, do not use metal reinforced line.
2. Pinch the slotted area on the both sides of the spool
housing to unhook the bottom cap.
10. Storage
Aged fuel is one of major causes of engine starting failure. Before storing the unit, empty the fuel tank and run the
engine until it uses all the fuel left in the fuel line and the carburetor. Store the unit indoor taking necessary measures
for rust prevention.
9. Maintenance