Yamaha YST-MS35D - Manual (Page 6)

E-
2
Controls & Connectors
1 USB INPUT
Use the included USB cable to connect this port to
the USB port on the computer.
2 TO RIGHT SPEAKER
Connect the 8-pin cable from the right satellite
speaker to this connector.
3 INPUT 1/2
You can input two audio sources to the speaker
system from these input jacks. For example, you
can connect the output of a CD-ROM player and a
personal computer here. The two audio sources are
mixed together by the speaker system.
4 TO LEFT SPEAKER
Connect the RCA pin plug cable from the left sat-
ellite speaker to this connector.
5 BASS control
Allows you to adjust the volume level of the sub-
woofer.
A typical (recommended) setting is the position
between one o’clock and two o’clock.
Rotating the control clockwise will increase the
volume level, and rotating the control counter-
clockwise will decrease the level.
6 DC connector
Connect the included AC adaptor to this connector.
Press the
(standby/on) button on the right satel-
lite speaker to turn the power on or standby.
7 VOLUME control
Allows you to adjust the volume level of the entire
speaker system.
Rotating the control clockwise will increase the
volume level, and rotating the control counter-
clockwise will decrease the level.
8 (standby/on) button/indicator
Press this button to turn on the power to the
speaker system. Its indicator lights up. Press the
button again to turn the speaker system to standby
mode.
Before pressing this button, make sure that the
VOLUME control setting is lowered. A small elec-
trical current flows through the speaker system
even if the standby/on button is turned off.
VOLUME
1
INPUT
USB
INPUT
TO RIGHT
SPEAKER TO LEFT
SPEAKER BASS
0 10
DC 15V
2
INPUT
2 3 4 5 6
Rear
(Subwoofer) (Right satellite speaker)
Top
7
8
1