Yamaha SW-3 - Manual (Page 10)

1
Set the VOLUME control to minimum.
2
Turn on the power supply to all the components.
3
Play any source and adjust the amplifier’s volume control
to the desired listening level.
4
Turn up the VOLUME control gradually to adjust the
volume balance between this unit and the main speakers.
5
Adjust the HIGH CUT control to the position where the
desired response can be obtained.
Notes
• Once the volume balance between this unit and the main
speakers is adjusted, you can adjust the volume of your
whole sound system by using only the amplifier’s volume
control.
• For adjusting the VOLUME control and the HIGH CUT
control, refer to “FREQUENCY CHARACTERISTICS” on
the right hand.
For effective adjustment of the HIGH CUT control
First set this control at about the main speakers’ rated
minimum reproduceable frequency. Then turn up the
VOLUME control gradually and set it at a level where you can
obtain a little more bass effect than when this unit is not used.
On the basis of this setting, if desired, adjust the VOLUME
control and the HIGH CUT control again.
*
The main speakers’ minimum reproduceable frequency can
be looked up in the speakers’ catalog or owner’s manual.
10
ADJUSTING VOLUME
POWER HIGH CUT VOLUME
I50 Hz 0 I0 50 Hz
OFF
ON
2 5 1, 4