Cleaning and maintenance – Zanussi ZBS 862 User Manual

Page 14

Advertising
background image

73

General Cleaning

Before cleaning, always allow the oven to
cool down.

When using spray cleaning products, be
careful not to spread them on the heating
elements or on the thermostat sensor.

Never use harsh abrasives, steel wool or
cleaners with bleach, as they could damage
the enamel and the oven door glass.

The Oven Cavity

The enamelled oven cavity is best cleaned whilst the
oven is still warm. It is advisable to wipe the oven over
with a soft cloth soaked in warm soapy water after each
use. However, from time to time, it will be necessary to
do a more complete cleaning, using a proper oven
cleaner.
In case of particularly tough stains, you can use some
warm vinegar.

If cooking fruits, some over-heated natual acids

can squeeze and settle on the oven enamel, causing
stains quite difficult to remove. This could affect the
enamel brightness, but it will have no consequence on
the oven performances. To avoid these stains to be
burnt out during the next cooking, carefully clean the
oven cavity after all fruits cookings.

The Oven Door and its gasket

Before cleaning the oven door, we recommend you to
remove it from the oven.

Proceed as follows:
a) open the oven door completely;
b) find the hinges linking the door to the oven (fig

6);

c) unlock and turn the small levers located on the

two hinges (fig. 13);

d) handle the door by its left- and right-hand

sides, then slowly turn it towards the oven until
it is half-closed;

e) gently pull the oven door off its site (fig. 14);
f) place it on a steady plan;
g) unscrew the two screws marked with lett. A

fig.14;

h) pull up the oven door glass and take it away

from the oven door.

Clean the oven door glass with warm water and a softh
cloth only.
Once the cleaning is carried out, refit the oven door,
following the procedure in reverse.

Fig. 13

Fig. 14

The correct operation of the oven is ensured by a gasket
placed round the edge of the oven cavity.

Periodically check the condition of this gasket.
If necessary, clean it without using abrasive
cleaning products.

If the gasket shows to be damaged, call you
local Zanussi Service Centre. Do not use the
oven until it has been repaired.

FO 0288

FO 0027

Cleaning and maintenance

Advertising