Manual tape-programming – Yamaha CDX-480 User Manual
Page 16
1
Follow steps 1 – 4 on page 15.
2
3
Select the track numbers (to be recorded on side A) in
the desired order.
* Programmed track numbers are illuminated on the
display. You can select a track which can be
programmed for the remaining time of (the side of) the
tape from track numbers flashing on the display, but you
cannot select any darkened track number.
4
When track selection for side A is finished, press the
TAPE button.
5
Select the track numbers (to be recorded on side B) in
the desired order.
6
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
7
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button on
this unit.
Notes
•
If, in step 3 or 5, “E rr” appears in the display, the track
number just selected cannot be programmed because there
is not enough time remaining on the tape. However, at this
time, if any other track number is flashing continuously in the
display, you can program it instead of the unprogrammable
one.
•
In step 3 or 5, each time a selection is made, the track
number and the tape’s remaining time will be displayed, and
then the display will change to indicate the number of the
next program.
•
CD synchronized recording function can be used if your tape
deck is compatible with it. In this case, in step 6 and 7, press
the SYNCHRO button and then press the PLAY button on
this unit’s remote control transmitter. Recording
automatically begins. (For details, refer to page 19.)
16
Notes on tape programming
•
To check, cancel or correct program data, refer to page 14.
* In checking the program data, note that “Pu” appears
between track numbers for side A and side B.
•
Up to a maximum of 25 tracks can be programmed. If,
however, the PAUSE mode is inserted, it is counted as one
track.
•
This function can be used to program up to track number 24.
If the disc has more than 24 tracks, track number 25 and
thereafter will not be programmed.
Ⅲ
Manual tape-programming
This is for recording desired tracks in any desired order onto a tape.
PROG
PROGRAM
A
1 2 3 4 5 6 7 8 9 10 11 12
TOTAL
REMAIN
TAPE
10
1
2
3
4
5
6
7
8
9
0
+
10
1
2
3
4
5
6
7
8
9
0
+
4
10
DIMMER
TIME
OPEN/CLOSE
PROG
CLEAR
SPACE
S/F
RANDOM
REPEAT
1
2
3
4
5
6
7
8
9
0
+
SKIP
PLAY
PAUSE
SEARCH
STOP
INDEX
OUTPUT LEVEL
+
–
TAPE
PEAK
SYNCHRO
6, 7
3, 5
7
2
A pause mode is programmed.