X10 Wireless Technology AIRPAD 1 - Manual (Page 4)

6 7
First charge the battery in your AirPad,
connect the included power supply to the
jack on the side of your AirPad (labeled
DC 5V) and plug the power supply into
an AC outlet. It may take up to 4 hours to
fully charge the unit.
Getting Started
The House symbol takes you to your Home screen at any
time. It shows up in a few places but it’s always visible in the top
left hand corner of the screen.
The back symbol at the top right hand corner of the screen
takes you back one screen each time you touch it. (You can also
press the hard key on the top of your AirPad (labeled on the back
of the AirPad as ESC).
Setting the Date and Time
To Set the Date and Time
1. On your Home screen, touch on the Settings icon.
2. Scroll down and touch Date & time. (If you don’t see it, you
might need to touch the Back icon to get to the correct screen).
Getting Started, cont.
USB Host USB DC 5V Headphones HDMI out MicroSD card slot
ESC Menu On/Off Reset/Mic
The AirPad does NOT charge via the included USB cable.
For best battery performance leave your AirPad charging overnight
or when not in use. See also page 20.
You can read various sections of this manual at any time to learn
how to accomplish specifi c tasks. You can also visit X10’s Wiki
on-line at: http://kbase.x10.com/wiki/airpad
Also see our AirPad Forums at: http://forums.x10.com
To turn your AirPad on
Press and hold the round ON/OFF button on the top of the unit until
the Android logo appears in the top left hand corner of the screen.
Release the button and wait while the unit “boots up.” Then swipe
the lock icon with your fi nger to unlock it.
To suspend the AirPad (Sleep mode)
Note that this still uses power and can run the battery down quite
quickly if Wi-Fi is turned on. The AirPad will go to sleep by itself if
you do nothing for a while. To force it to go into sleep mode, press
and release the round ON/OFF button on the top of the unit.
To turn the AirPad completely off (shut it down)
Press and hold the round ON/OFF button on the top of the unit until
you see a screen that shows the option to Power off. Touch that button
on the screen. Then touch OK. Next time you power on you will need
to follow the steps above. If however the AirPad was just “asleep”
then just pressing the ON/OFF button displays a screen where you
can swipe the lock icon with your fi nger to unlock it.