Setting up the speakers, Stand mounting the front speakers, Wall mounting the front speakers – Yamaha NS-AP9500M User Manual

Page 4

Advertising
background image

NS-AP9500M/9600E

4

Stand mounting the front speakers

You can use the supplied speaker stands SPS-9500T for table top installation.
For assembly instructions, please refer to the SPS-9500T owner’s manual
which can be found in the SPS-9500T box.

Wall mounting the front speakers

The front speakers may also be hung on a wall, utilizing the key holes on the rear of the speakers.

Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the rear of the
speaker on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the “key hole” opening.

SETTING UP THE SPEAKERS

WARNING

The front speakers weigh 7.92 lbs (3.6 kg) each. Do not mount them on thin plywood or a wall with soft
surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall.
This will damage the speakers and can cause personal injury.

Do not fasten the speaker to a wall with nails, adhesives, or any other unstable hardware. Long-term use
and vibrations may cause them to fall.

To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or
floor molding.

Secure installation is the purchaser’s responsibility.

*a

*b

Wall / wall support

Tapping screw
(Available at the
hardware store)

* Do not use this screw hole.

Use the key hole

Use the key hole

*a: Min 1-1/2” (38 mm)
*b: 7/32” (5.5 mm)

Screw
diameter
1/8-3/16
(4-4.5 mm)

The screw holes are designed
specifically for use with the inch
screws supplied with the SPS-9500T
speaker stands.

Advertising
This manual is related to the following products: