Yamaha CRW2200SX - Manual (Page 22)

Setup Procedures
13
Notes
• The SCSI ID number for each device on the chain must be unique. Make sure the CRW2200SX
drive’s SCSI ID number is not the same as that of any other device on the chain. By factory
default, the CRW2200SX drive is assigned ID number “1” but this can be changed.
• When setting the dip switch, move the lever completely upward or downward.
➁ ➁ ➁ ➁ Termination
Terminators prevent SCSI signals from being reflected off the last device in the
chain. The SCSI terminator dip switch should be set to ON if the CRW2200SX
drive is the last device on the SCSI chain. If the CRW2200SX drive is not the
last device on the chain, the TERMINATOR dip switch should be set to OFF.
Note
The default setting of the Terminator dip switch is ON.
SCSI card
(terminated)
Hard disk drive
(unterminated)
Computer
CRW2200SX
(terminated)
Termination ON (Default) Termination OFF
Set to ON if the CRW2200SX
drive is the last device on
the SCSI chain Set to OFF if the CRW2200SX
drive is not the last device on
the SCSI chain