Sliprobot L1 - Manual (Page 15)

15
SETTINGS AND SERVICING
If one cutting link gets too deep or too
shallow, this can be changed by
slackening screw 1, 2, 3 or 4 and
turning motor 5 as shown.
Turn the motor in the relevant
direction and tighten the screws.
The machine is largely maintenance-
free, but it should be kept clean by
removing any grinding dust.
The wire (3) must be inspected after
40 hours’ running to check that it is
not in poor condition and that its
tension is correct.
The incoming power must always
be switched off.
A = Deeper grinding
on this cutting
link. B = Deeper grinding
on this cutting
link.
3
Replace the wire
immediately if it
is in a poor
condition.