3M MP8725 - Manual (Page 16)

3M ™ Multimedia Projector MP8725 © 3M 1999
ENGLISH
5.1 Cleaning the Air Filter
✔ Note
Clean the air filter about every 50 hours, or when CHECK THE AIR FLOW is displayed.
1. Turn off the MAIN POWER switch of the projector and pull out power cord. Let cool for 20 minutes.
2. Press tab (2) to release air filter door.
3. Carefully remove foam air filter screen (3) from air filter door.
4. Vacuum air filter and door to remove dust and dirt.
5. Re-install the air filter and replace the air filter door.
✔ Note
If air flow is restricted due to dust accumulation on filter, the projector may shut down due to over heating. The
message CHECK THE AIR FLOW will display if ventilation becomes restricted.
Section 5: Maintenance
14
Figure 5.1 Remove Air Filter
Power
1
3
EPS-09A
STANDBY/ON
INPUT MUTE
MENU RESET
LAMP TEMP
2