3M S10 - Manual (Page 28)

28
Item Description
VIDEO NR
Select a Noise Reduction Mode:
HIGH MIDDLE LOW
• This function performs only at a VIDEO input or a S-VIDEO input. At a VIDEO
input of NTSC 3.58, this function performs only when the TURN OFF is
selected under the 3D-YCS.
• When the HIGH, the MIDDLE or the LOW is selected, the noise on screen is
reduced according to each mode.
• When this function is excessive, it may cause a certain degradation of the
picture.
PROGRESSIVE
Select the Progressive Mode:
TV FILM TURN OFF
• This function performs only at an interlaced signal of a VIDEO input, a S-
VIDEO input or a COMPONENT VIDEO input of 525i or 625i signal. The FILM
mode is adaptable to the 3-2 Pull-Down system to the conversion.
• When the TV or FILM is selected, the screen image will be crisper. But it may
cause a certain defect (for example, jagged line) of the picture at a quick
moving object. In such a case, please select the TURN OFF, even though the
screen image may lose the crisp.
• This function may cause a certain degradation of the picture. In such a case,
please select the TURN OFF.
INFORMATION
Display the Information:
Pressing the
or the ENTER button performs this function.
• Use this function when you want the information about the current input (ex.
the resolution and the vertical frequency at a RGB input, the signal type of a
video input) and setting states of the COMPONENT, the VIDEO and the
FLAME LOCK.
S2-ASPECT
Select the S2-ASPECT Mode:
TURN ON TURN OFF
• This function performs only at a S-VIDEO input.
• When the TURN ON is selected, an S2-Video signal can be identified and the
optimum aspect ratio is automatically selected.
• When the ASPECT button of the remote control is used or the ASPECT item of
the MAIN menu is operated, the S2-ASPECT mode will be switched to the
TURN OFF automatically.
RESET
Reset the INPUT Menu Items:
Selecting the EXECUTE performs this function.
EXECUTE CANCEL
• The items of the INPUT menu are collectively returned to the initial setting.
Note that the INFORMATION item is not reset.
INPUT Menu (continued)
Multifunctional Settings (continued)