3Com 09-1632-000 User Manual
Page 14
14
C
ONFIGURING
Y
OUR
O
FFICE
C
ONNECT
NETB
UILDER
10 B
RIDGE
/R
OUTER
g In the start field, click the arrow and choose 2.2.
h In the LocalDialNo field, enter the second local dial
number string in quotes. For example, enter:
"4085551002"
i
Click Apply.
2 Use the SPID Wizard to detect the switch type and SPID
values.
a In the Dial On Demand ISDN Setup section of the
navigation frame, click the PATH SpidWIZard link.
b In the start field, click the arrow and choose 2.
c In the SPIDWIZard field, click the arrow and choose
Trigger.
d Click Apply.
3 Enable the ISDN paths.
a In the Dial On Demand ISDN Setup section of the
navigation frame, click PATH CONTrol.
b In the start field, click the arrow and choose 2.1.
c In the end field, click the arrow and choose 2.2.
d In the CONTrol field, click the arrow and choose
Enabled.
e Click Apply.
Wait for SPID Wizard to complete SPID identification.
SPID detection can take up to three minutes.
As the SPID Wizard is running, execution messages are
displayed that show the detected SPID values and switch
type.
If the execution messages show that SPID identification
and switch type detection was successful, go to step
step 7.
If the execution messages show that auto detection of
SPID values has failed, you must enter them manually.
Go to step 4.
OC10.book Page 14 Thursday, May 13, 1999 2:33 PM