Fein BF 10-280E - Manual (Page 13)

13 en
en Original Instructions for Belt File.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Gripping surface
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Low sanding-belt speed
High sanding-belt speed
WARNING
Character Unit of measure,
international Unit of measure,
national Explanation
P
1
W W Power input
P
2
W W Output
v
0
m/s m/s Sanding-belt speed
U V V Rated voltage
f Hz Hz Frequency
M... mm mm Size of metric thread
Ø mm mm Diameter of a round part
l
1 mm mm Sanding-belt length
l
2 mm mm Sanding-belt width
kg kg Weight according to EPTA-Procedure 01/2003
L
pA
dB dB Sound pressure level
L
wA
dB dB Sound power level
L
pCpeak
dB dB Peak sound pressure level
K... Uncertainty
a m/s 2 m/s 2 Vibrational emission value according to EN 60745
(vector sum of three directions)
a
h
m/s
2
m/s
2
Vibrational emission value (sanding)
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
Basic and derived units of measure from the inter-
national system of units SI.
OBJ_BUCH-0000000010-002.book Page 13 Tuesday, October 5, 2010 10:38 AM