Fein BLK5.0 - Manual (Page 21)

21 en
BLK2.0/BLK3.5: For template cuts, the template is traced
via the lower cylindrical part of the punch guide. The
clearance between template and the actual cutting edge is
2.5 mm.
The template should be at least 2 mm thick; the total
thickness of template and work piece may not exceed
5.5 mm.
BLK1.6: For cutting deep-channel trapezoidal sheet metal,
the optionally available profile set 160 can be mounted.
(see page 14)
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool.
The total insulation of the power tool can be impaired.
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air,
and connect a residual current device (RCD) on the line
side.
Lightly grease the sliding surfaces between die
holder and punch.
When the power tool’s power cord is damaged, it must
be replaced by FEIN or by an authorized FEIN Service
Agent, in order to avoid hazardous situations.
If required, you can change the following parts yourself:
Application tools
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer’s warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environmental-friendly recycling.
OBJ_BUCH-0000000022-001.book Page 21 Monday, January 31, 2011 9:06 AM