Fein ASq 672-1 - Manual (Page 14)

14 en
Original Instructions for Drill.
Symbols, abbreviations and terms used.
Symbol, character Explanation Symbol, character Explanation
Do not touch the rotating parts of
the power tool. 1st gear/2nd gear/3. gear/4. gear
Make sure to read the enclosed
documents such as the Instruction
Manual and the General Safety
Instructions. Drilling diameter, steel
Before commencing this working
step, pull the mains plug out of the
socket. Otherwise there will be
danger of injury if the power tool
should start unintentionally. Drilling diameter, aluminium
Use eye-protection during opera-
tion. Drilling diameter, wood
Use ear protection during opera-
tion. Tap
This sign indicates a possible dan-
gerous situation that could cause
severe or fatal injury. Diameter for reaming
Confirms the conformity of the
power tool with the directives of
the European Community. d
1
= Clamping range of drill
chuck
d
2
= Shank size of drilling shaft
d
3
= Collar diameter
Worn out power tools and other
electrotechnical and electrical
products should be sorted sepa-
rately for environment-friendly
recycling. MT Morse Taper size (ISO 296)
Product with double or rein-
forced insulation Weight according to
EPTA-Procedure 01/2003
Ø Diameter of a round part Low speed
High speed
3.
Fe
Al
WARNING
3 41 01 095 06 0.book Seite 14 Montag, 15. März 2010 1:02 13