頁面 7, En g lis h, 2 pcoip pcie host card installation – Leadtek WinFast VP200P User Manual
Page 7: 3 establishing a pcoip connection
4
2 PCoIP PCIe Host Card Installation
1. Check the jumpers on the Host card to ensure they are in the correct setting. See
Host Card Jumper Settings for details.
2. Be sure the Host PC is turned off and unplugged from AC power.
3. Open the PC's case.
4. Install the Host Card into a free PCIe slot and secure the metal bracket.
5. Connect the DMS-59 to dual DVI cable to the Host Card's DMS-59 connector (22)
and connect the DVI-1 connector (13) to the PC's graphics card. If you are using
dual monitors, connect the graphics card's second DVI-out port to the DVI-2
connector (14).
6. Use an Ethernet cable to connect the Ethernet switch or router to the Host Card's
Ethernet jack (21), then power on the Ethernet switch or router.
7. Close the Host PC's case and plug the Host PC into a surge-protected AC outlet.
3 Establishing a PCoIP Connection
1. Power on the host PC.
2. Wait until the “Connect” button on the Portal On Screen Display (OSD) user screen
is active.
3. Use the mouse connected to the Portal to click “Connect” on the OSD screen. The
message “Discovering hosts, please wait …” will appear on the monitor.
4. A list of available Hosts on the network will appear on the OSD.
5. Select the Host Card you wish to connect and click “OK”.
6. The Portal's PCoIP LED (1) will light green, indicating a successful PCoIP
connection.
7. If you are using dual monitors, remember to configure the graphics card for dual-
monitor operation.
8. When the Host PC finishes booting, use the Portal as you would a normal desktop
PC.
NOTE
If the “Connect” button on the Portal OSD is inactive or if the Portal can not discover any
Host Cards on the IP network, check the network connection and be sure the Ethernet
switch or router is powered on.
Additional Notes
Monitor types:
In addition to DVI monitors, the Portal is compatible with analog VGA and digital HDMI
monitors. Simply attach a DVI-to-VGA or DVI-to-HDMI adapter to the Portal's DVI
connector.
Connect button is inactive
Connect button is active
E
n
g
lis
h