Leadtek TERA2240 Host Card - Manual (Page 7)

4
Refer to PCoIP Zero Client & Host Administrator Guide for troubleshooting
and additional information, available at techsupport.teradici.com
English
6. Connect the host card to your network using the Ethernet port.
7. Connect the host card to one or more GPUs. Starting with port 1 on the host card, use the included mini-
DisplayPort cable to connect to your GPU. Next use port 2 for the 2nd monitor, and so on.
8. Replace the chassis cover and reconnect power cables.
9. Start up host.
ESTABLISHING A PCoIP CONNECTION
Your zero client is pre-configured to connect directly to a PCoIP host card, but can be configured to use a
third party connection broker such as VMware View to connect to virtual desktops or PCoIP host cards.
Direct connect to host card
1. Power on host PC with PCoIP host card.
2. Power on the zero client and the connected displays.
3. Ensure the zero client is on the same network as the host card.
4. Wait until the “Connect” dialog appears on screen.
5. Select “Connect” and you will see the message “Discovering hosts, please wait…”.
6. A list of available hosts is displayed.
7. Select the host card you wish to connect to and click “OK”.
8. The display will show the host PC screen and the zero client’s Session LED on the front panel will turn
green indicating a successful PCoIP connection.
Connect to VMware View brokered host card
1. See PCoIP Zero Client & Host Administrator Guide for detailed setup instructions.